Matek Systems GNSS SAM-M10Q

Matek Systems GNSS SAM-M10Q

Product description

Matek Systems GNSS SAM-M10Q

The SAM-M10Q features the standard u-blox M10 precision GNSS platform and provides exceptional sensitivity and acquisition time for all L1 GNSS signals. The SAM-M10Q supports simultaneous reception of four GNSS (GPS, GLONASS, Galileo and BeiDou). The high number of visible satellites allows the receiver to select the best signals. This maximizes position availability, especially in difficult conditions such as deep urban canyons. U-blox' Super-S (Super Signal) technology provides high RF sensitivity and can improve dynamic positioning accuracy in non-line-of-sight scenarios.

The 15 x 15 mm2 high gain patch antenna provides the best balance between performance and small size. The omnidirectional antenna radiation pattern increases flexibility in device installation.

Specifications

• GNSS u-blox SAM-M10Q-00B (GPS, GLONASS, Galileo and BeiDou)
• No magnetic compass built in
• Patch antenna 15*15*4mm
• Input voltage range: 4~9V (5V pad/pin)
• Power consumption: 10mA
• UART baud rate: 9600 standard
• Operating temperature: -20~80 °C
• UART(TX, RX) interface for GNSS SAM-M10Q-00B
• JST-GH-4P connector (SM04B-GHS-TB). 1.27mm pitch
• GNSS PPS LED, green. (Lights up after power on, flashes (1Hz) when GNSS receives 3D fix)
• Protocol: UBX(u-blox) 5Hz@GPS+GAL+BDS B1C+GLO or NMEA 1Hz
• 26mm*16mm*8mm
• 7.5g

Content

• 1x SAM-M10Q
• 1x JST-GH-4P to JST-GH-4P 20cm silicone cable