Matek Systems Flight Controller F405-STD with OSD and Baro

Matek Systems Flight Controller F405-STD with OSD and Baro

Product description

Matek Systems Flight Controller F405-STD with OSD and Baro

Technical data

• MCU: 168 MHz STM32F405RGT6
• IMU: 32K ICM20602 Gyro / accelerometer (SPI)
• Baro: BMP280 (I2C)
• OSD: BetaFlight OSD with AT7456E chip
• Black box: MicroSD card slot (SD / SDHC)
• VCP, UART1, UART2, UART3, UART4, UART5
• Built-in inverter for SBUS input (UART2-RX)
• PPM / UART enabled: UART2-RX
• SoftSerial on TX2, S5 or S6 optional
• Camera control on S6 or DAC optional
• Smartaudio & Tramp VTX protocol supported
• Battery voltage sensor: 1:10
• Current sensor: No (option FCHUB-6S, FCHUB-VTX, FCHUB-W)
• BEC 5V: No (option FCHUB-6S, FCHUB-VTX, FCHUB-W)
• LDO 3.3 V: max. 300 mA
• I2C1 SDA & SCL: Yes
• WS2812 LED strips: Yes
• Beeper: Yes
• RSSI: Yes
• Dimensions: 36 x 36mm
• Mounting: 30,5 x 30,5mm
• Weight approx.: 7g

• 3 x LEDs for FC STATUS (blue, red) and 3.3V display (red)
• 6 x PWM / DShot outputs without conflict
• Option for 2x 2812LED outputs
• 5 x UARTs
• 1 x group of 5V / G / S1 / S2 / S3 / S4 pads for 4in1 ESC signal / GND
• 4x pair of corner pads for ESC signal / GND connections (DSHOT compatible)
• 1x pair of I2C1 pads
• 1x side button for the BOOT (DFU) mode
• 1x 16-pin bottom-mounted FFC slot for FCHUB-6S, FCHUB-VTX or FCHUB-W connection
• 36 x 36mm board with 30,5mm mounting holes

Scope of delivery

• 1 x flight controller
• 2 x 0,5 mm x 16Pin 5cm flexible flat cable
• 4 x M3 vibration spacers