Matek Systems PDB for Wings FCHUB-W

Matek Systems PDB for Wings FCHUB-W

Product description

Matek Systems PDB for Wings FCHUB-W

specifications

• Input voltage range: 9 ~ 30V (3 ~ 6S LiPo) w / TVS protection
• 2x ESC power pads
• Current Senor: 104A, 3.3V ADC, Scale 317
• 4x BEC on board
• 3x LED indicators for 5V, 10V & Vx
• Soldering Holes & Pads
• + & -: Bettery & ESC power pads
• Curr: Current sensor output
• Vbat: Bettery voltage
• G: Ground
• 3V3: LDO 3.3V
• 5V: BEC 5V
• 10V: BEC 10V
• Vx: BEC 5V / 6V / 7.2V ADJ
• FFC connection

Compatible with MATEKSYS FC F405-STD, F722-STD, F405-OSD

• MT1: Engine1 of INAV Flying Wing & Airplane
• MT2: Engine2 of INAV Flying Wing & Airplane
• SV3 ~ SV6: Servo 3 ~ 6 of INAV Flying Wing & Airplane
• VTX: Video Transmitter signal
• TX5 & RX5: UART5 of F405-STD / F722-STD / F405-OSD
• BEC 5V output

Designed for Flight Controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, GPS module

• DC / DC synchronous buck regulator
• Voltage: 5.0 +/- 0.1VDC
• Continuous current: 2 amps, Max.3A
• Output ripple: 20mV (VIn = 24V, VOut = 5V @ 2A load)
• Short-circuit tolerant (2 seconds)
• BEC 10V output

Designed for Video Transmitter, Gimble

• DC / DC synchronous buck regulator
• Voltage: 10.0 +/- 0.2VDC (Input voltage> 11V)
• Continuous current: 2 amps, Max.3A
• Output ripple: 20mV (VIn = 24V, VOut = 10V @ 2A load)
• Short-circuit tolerant (2 seconds)
• BEC Vx output

Designed for servos

• DC / DC synchronous buck regulator
• Voltage adjustable, 5V Default, 6V or 7.2V via jumper
• Continuous current: 5 amps, max.5.5A
• Output ripple: 50mV (VIn = 24V, Vout = 5V @ 5A load)
• Short-circuit tolerant (2 seconds)
• BEC 3.3V output

Designed for Baro / Compass module and Spectrum RX

• Linear regulator
• Continuous current: 500mA
• Physical

size

• Mounting: 30.5 x 30.5mm, Φ3mm
• Dimensions: 52 x 36 x 6 mm
• Weight: 13g