BetaFPV BT2.0 Connector Set: 5 Male, 5 Female

BetaFPV BT2.0 Connector Set: 5 Male, 5 Female

Product description

Small connectors, big impact. The BetaFPV BT2.0 connector is one of those unassuming components that’s often underestimated in an FPV setup—until you realize just how much it affects performance. After all, the connection between the battery and the drone determines how much energy actually gets through. And that’s exactly where BT2.0 makes the difference.

At its core, it’s all about physics: Every contact resistance costs energy. Traditional PH2.0 connectors slow down the flow of current like a narrow road during rush hour. The BT2.0, on the other hand, widens the “conduction path” with optimized 1.0mm banana pins and a larger contact area. The result: less voltage sag, more usable power, and noticeably longer flight times.

With up to 9A continuous current and 15A burst current, the BT2.0 delivers significantly more power than conventional 1S connectors. This is immediately noticeable, especially with modern brushless Whoops: more stable voltage, more consistent power, and fewer annoying low-voltage warnings in the middle of a flight.

And since FPV is rarely a gentle affair, durability was also a priority. The more robust construction ensures that the connectors last longer—even with frequent plugging and unplugging.

In short: If you want to get the most out of your 1S setup, the BT2.0 Standard is practically a must-have. It’s not an upgrade for show—it’s for real performance.

Technical Specifications

General

• Product: BetaFPV BT2.0 Connector Set
• Type: Connector set for 1S LiPo batteries
• Set Contents: 5× Male + 5× Female

Electrical Performance

• Continuous current: up to 9A
• Peak current (burst): up to 15A

Advantages over PH2.0

• Lower internal resistance
• Reduced voltage sag
• Higher discharge efficiency
• Longer flight time

Dimensions & Weight

• Male connector:
  • Size: 6.0 × 4.2 × 10.5 mm
  • Weight: 0.34 g
• Female Connector:
  • Dimensions: 6.0 × 4.2 × 8.3 mm
  • Weight: 0.24 g

Design

• 1.0 mm banana pin design
• Enhanced contact area for better current transmission
• Pole marking integrated into the housing