Building an FPV Drone Up to 7" (with Betaflight)

Building an FPV Drone Up to 7" (with Betaflight)

Product description

Important Note: Please contact us via email at support@meilon.de before making a purchase and read the complete procedure and disclaimer at the following link: https://www.fpv24.com/de/blog/148/dienstleistungsprodukte-infos-und-faq

Assembly of an FPV drone up to 7" using customer-supplied parts (with Betaflight configuration, including binding the receiver and goggles)

Have you selected the right components for your new copter but would rather leave the assembly to an experienced technician? Or do you lack the time for the soldering work and setup? We’ll take care of it for you.

With our assembly service, one of our workshop technicians will assemble the individual parts you’ve supplied into a ready-to-fly FPV drone (for frame sizes up to 7 inches). With over 13 years of experience in the FPV field, we ensure clean soldering, neat cable management, and a technically sound build.

With this package, in addition to mechanical assembly, we also handle the complete software setup. Your copter will be configured in Betaflight and paired directly with the receiver you sent along, as well as your FPV goggles. After unpacking, the drone is ready to fly right away.

Note: For copters larger than 7 inches, please send an email to our support team.

Scope of this service product:

• Frame Assembly: Professional assembly of your frame (up to 7 inches) including all structural and TPU parts.

• Wiring & Soldering: Reliable soldering of the flight controller (FC), ESCs, motors, camera, and video transmitter (VTX), as well as any other components (upon request), such as a GPS module.

• Betaflight Configuration: Installing/updating the appropriate firmware, configuring ports, setting the receiver protocol, basic sensor setup, and configuring the switch assignments for your remote control (arm, flight modes, beeper, etc.).

• Binding: Binding your receiver to your transmitter and pairing the video system with your goggles.

• Functionality check: Visual inspection, pre-power-up test using a smoke stopper, and verification of motor rotation direction. Short test flight.

PID tuning is not included. This can be purchased separately here.

What we need from you:

• All components required for assembly

• Frame

• Motors

• ESC/FC stack

• FPV camera, including video transmitter

• Antenna(s)

• Receiver

• Propellers and other products, such as a GPS module.

• Your remote control (for configuration and binding).

• Your FPV goggles (for binding the video system).

Workshop accessories and consumables do not need to be included in the shipment.