Receiver installation, including setup

Receiver installation, including setup

Product description

Important Note: Please contact us via email at support@meilon.de before making a purchase, and read the full procedure and disclaimer at the following link: https://www.fpv24.com/de/blog/148/dienstleistungsprodukte-infos-und-faq

Do you want to upgrade your copter to a new radio system, or have you purchased an analog/digital BNF copter without a receiver? Installation and proper soldering onto the flight controller require a steady hand and knowledge of the relevant protocols.

One of our technicians will handle the neat installation and setup of your receiver for you. With over 13 years of experience, we ensure professional wiring, secure solder joints, and the correct placement of antennas for optimal reception. We’ll then configure the system in the software and connect the receiver directly to your remote control so you’re ready to fly right away.

Note: For copters larger than 7 inches, please send an email to our support team.

Scope of this service product:

• Hardware Installation & Soldering: Professional soldering of the receiver to the flight controller, ensuring correct UART pinout.
• Antenna installation: Secure mounting of the receiver antenna on the frame, optimized for reception, to prevent damage from the propellers.
• Software configuration: Setting up the appropriate receiver protocol (e.g., ELRS, Crossfire) in Betaflight and verifying channel assignments.
• Binding: Fully binding the new receiver to the remote control included in your shipment.
• Functionality Check: Final test in the configurator to verify that all control commands from your sticks and switches are transmitted correctly.

What we need from you:

• Your drone, into which the receiver is to be installed.
• The receiver to be installed (if not purchased separately from our store).
• Your remote control (absolutely necessary for binding and the function test).