Radiomaster RP1 ELRS 2.4GHz Nano Receiver

Radiomaster RP1 ELRS 2.4GHz Nano Receiver

Product description

Radiomaster RP1 ELRS 2.4GHz Nano Receiver

Currently, the ELRS radio system does not yet have approval in Germany, which means that it is not officially released for operation in the country.

However, the Federal Network Agency is currently in the process of reviewing whether approval for ELRS can be considered.

The purpose of this review is to evaluate the technical, legal and safety aspects of the radio system to determine whether it complies with national regulations and standards and can be used without hesitation.

RP1 Nano ExpressLRS 2.4 GHz Receivers - The Ultimate Open Source Receivers for FPV and Long Range Flying

The RP1 and RP2 2.4 GHz ELRS Nano series receivers are open source receivers based on ExpressLRS. Developed by Jye Smith, a member of the ExpressLRS development team, these receivers offer outstanding performance and flexibility. Featuring an ESP8285 microcontroller and the SX1280 RF chip, they offer the perfect combination of reliability and performance.

The RP1 features a UFL antenna jack for use with a long range antenna, while the RP2 has an integrated ceramic antenna that is extremely lightweight and small, ideal for racing.

The RP1 and RP2 receivers are equipped with WLAN, so you can conveniently update the firmware via WLAN and configure the receiver with your PC or cell phone via the integrated WebUI.

Thanks to the low latency and high update rate radio module, the RP1 and RP2 are great for FPV racing and long distance flying. Their ultra-lightweight and compact nano-size allows them to fit in virtually any drone or model aircraft. Point.

The upgraded PCB design provides better heat dissipation and the upgraded rigid antenna provides increased durability and performance. Additionally, there is an LED on the top of the PCB and the solder pads are improved to make soldering easier.

Specifications

• Model: RP1 Nano ExpressLRS 2.4 GHz Receiver
• Type: ISM
• Antenna: 65 mm 2.4 GHz T-antenna
• Maximum update rate of the receiver: 500 Hz / F1000 Hz
• Minimum update rate of the receiver: 25 Hz
• Operating voltage: 5V
• Weight: 2.2 g (including antenna)
• Dimensions: 13 mm x 11 mm x 3 mm
• Firmware version: ExpressLRS v2.4 pre-installed
• Firmware target: RadioMaster RP1/2 2400 RX
• Bus interface: CRSF

The RP1 and RP2 receivers offer you an unbeatable combination of performance, flexibility and convenience. Order now and take your FPV and long range flights to a new level!