BetaFPV F4 Brushless Flight Controller ESC Stack V2 BLHeli_32

BetaFPV F4 Brushless Flight Controller ESC Stack V2 BLHeli_32

Product description

BetaFPV F4 Brushless Flight Controller ESC Stack V2 BLHeli_32

After several months of research, the best combination of F405 4S Brushless Flight Controller with BLHeli_32 16A ESC has been launched, which fully supports the 4S power while maintaining the same performance. BLHeli_32 16A ESC is customized for Beta85X whoop drone. Meanwhile, Beta85X is currently the first micro drone with BLHeli_32 ESC.
BLHeli_32 is the third generation ESC firmware after BLHeli and BLHeli_S written for ESCs with 32-bit MCUs. With the increase of computing power, BLHeli_32 would allow faster input signals with lower latency and higher update rate, like Dshot1200!

Technical Data

• CPU: STM32F405 (overclocked to 240MHz)
• Six-axis: MPU6000
• Size: 26 mm x 26 mm, mounting pattern
• Firmware version: BETAFPVF405 (BEFH)
• OSD: Built-in BetaFlight OSD (STM32 controls the OSD chip via SPI in DMA mode)
• RX3 and TX3 are equipped with automatic inverter and support all RX including TBS Micro RX
• TX01 and RX01 ports are available for Frsky F-Port, DSM2/DSMX
• Buzzer solder pads
• Support programmable LED like WS2812 etc.
• Weight: 4.2g

Technical data ESC

• Support BLHELI_32
• Support PWM, Oneshot125, Oneshot42, Multishot, Dshot150, Dshot300, Dshot600, Dshot1200
• Input voltage: 3-4S lipo
• Continue current: 16A
• Peak current: 19A
• Firmware target: BETAFPV-16A-32bit
• MCU: STM32F051K66
• Motor connector: 1.25mm male header connector
• Weight: 4.4 g (7.7 g with XT30 cable)

Parts Update
The F405 4S FC board has an additional 4 pluggable connectors for ESC, VTX, RX and LED board, making installation easier and reducing staggered PIN assembly.

HOW TO ASSEMBLY FC & ESC
To make installation easier and reduce staggered PIN mounting, we have added a connector for the ESC connector. Separate installation, in case motor vibration could interfere between FC and ESC.

HOW TO ASSEMBLY FC & LED BOARD
To make installation easier, we added a connector for connecting LED boards.

RECOMMENDED RECEIVER PORT
To make installation easier, we have added a port for RX connection. All ports are available on this board. So you can connect any receiver on the card. For example.

• Frsky XM/XM+ receiver
• Flysky receiver
• TBS receiver
• DSMX receiver

Contents

• 1 * F405 4S BrushlessFlight Controller
• 1 * 16A BLHeli_32 ESC
• 1 * 4P cable for RX
• 1 * 3P cable for LED board
• 4 * Screws M1,4x4mm
• 4 * 1.2mm anti-vibration rubber damper