FETtec AIO 35A ESC 3S-6S N without OSD

FETtec AIO 35A ESC 3S-6S N without OSD

Product description

FETtec AIO 35A - N

What does "N" version mean?

This product has no analog onboard OSD.

The use of digital OSDs is possible as usual.

Features:

FC:

• Latest STM32G4 processor
• 170Mhz + Math accelerator
• MPU6000
• Designed for 12-25V supply voltage (3S-6S Lipo)
• 2x onboard BEC (max. 600mA each)
• 5V BEC for RX
• 5V/16V BEC for VTX (configurable and real pit*)
• 1x 8 pin connector for solderless connection to VTX, camera and OSD of digital systems
• VCC, GND, Video in, Video out, BEC 5V/16V, VCS/TX3, RX3
• 2x 4 pin connector for receiver and VTX
• Signal, telemetry, 5V, gnd
• Gnd, 5V, TX1, RX1
• 5 UART serials
• UART 1 free
• UART 2 used by receiver
• UART 3 free
• UART 4 free
• UART 5 occupied by ESCs / TLM / Onewire
• Solder pads for RGB LEDs
• Supported ESC Protocols
• PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
• KISS FC firmware

*real Pit-Mode:Supply pad switchable

ESC:

• Active current limiting @ 35A
• Input voltage: 3s-6s
• High quality 40V MOSFETs
• STM32G071 @ 64MHz
• up to 128 kHz motor PWM
• Full sine wave control
• Automatic input signal detection
• PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
• FETtec ESC firmware

Connector type: JST-SH-1mm

• Outer dimension: 30 x 37,5mm
  • Mounting holes arrangement: 20 x 20mm with M2 mounting holes (can be enlarged to M3)
• Height: 7,9mm
• Weight: 8.9g

Software

KISS Firmware - Software update via FETtec Configurator

FETtec ESCs Firmware - Software update via FETtec Configurator

Content

1x FETtec AIO 35A - N

1x capacitor 50V 470µF

2x open 4pin cable (one side JST connector)

1x open 8pin cable (one side JST connector)

Standoffs