Betaflight Configuration (including receiver configuration)

Betaflight Configuration (including receiver configuration)

Product description

Important Note: Please contact us via email at support@meilon.de before making a purchase, and read the full procedure and disclaimer at the following link: https://www.fpv24.com/de/blog/148/dienstleistungsprodukte-infos-und-faq

Is your copter fully assembled, but are you struggling to find the right settings in the software? For an FPV drone to fly stably and do exactly what you tell it to do with the control sticks, the software setup must be just right.

One of our technicians will handle the entire software setup for your copter. With over 13 years of experience in the FPV field, we’ll install the right firmware on your flight controller, configure all interfaces correctly, and ensure that your receiver communicates flawlessly with the drone. You’ll save yourself hours of searching through forums and get a properly configured drone back.

PID tuning is not included. This can be purchased separately here.

Note: For copters larger than 7 inches, please send an email to our support team.

Scope of this service product:

• Firmware update: Installation of the appropriate and stable Betaflight firmware for your flight controller.
• Port & Protocol Configuration: Correct assignment of the serial interfaces (UARTs) for receivers, video transmitters (VTX), GPS, or telemetry.
• Receiver configuration: Complete setup of your radio protocol (e.g., ELRS, Crossfire) in the Betaflight configurator.
• Switch Assignment & Modes: Programming the channels on your remote control for all important functions (such as Arm, flight modes, beeper, Crash Flip / Turtle Mode).
• Basic Setup & Sensor Check: Aligning the flight controller, calibrating the sensors, and verifying the motor rotation direction and correct assignment (motor mapping).

This product includes only software work and configurations on a copter that is already fully assembled and operational. Mechanical work, soldering, or repairs are not included.

What we need from you:

• Your fully assembled drone that is in working order on the hardware side. You must test it in advance using a smoke stopper to rule out any hardware issues.
• Your remote control (absolutely necessary to properly match the switch assignments and the receiver).
• If applicable, your video goggles.