Matek Flight Controller H743-SLIM Wing FC

Matek Flight Controller H743-SLIM Wing FC

Product description

Matek Flight Controller H743-SLIM Wing FC

Technical data

• Mounting: 30,5 x 30,5 mm, 4mm diameter with grommets 3mm diameter
• Dimensions: 36 x 36 x 5 mm
• Weight: 7g
• MCU: STM32H743VIH6, 480MHz , 1MB RAM, 2MB Flash
• IMU: MPU6000 (SPI1) & ICM20602 (SPI4)
• Baro: Infineon DPS310 (I2C2)
• OSD: AT7456E (SPI2)
• Black box: MicroSD card socket (SDIO)
• 7x Uarts (1,2,3,4,6,7,8) with built-in inversion.
• 13x PWM outputs (including "LED" pad)
• 2x I2C
• 1x CAN
• 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, Vbat2, Cur2)
• 3x LEDs for FC STATUS (blue, red) and 3.3V display (red)
• 1x SPI3 breakout
• USB Type-C(USB2.0)
• 1x JST-SH1.0_8pin connector (Vbat/G/Curr/Rx8/S1/S2/S3/S4)
• 1x JST-GH1.25_4pin connector (5V/CAN-H/CAN-L/G)
• Switch for two camera inputs
• 5V/Vbat filtered ON/OFF switch
• DJI FPV OSD is supported by any replacement UART
• Vbat input: 6~36V (2~8S LiPo)
• BEC: 5V 2A continued. (Max.3A)
• LDO 3.3V: Maximum 200mA
• No current sensor installed
• ADC Vbat2 pad supports max. 69V (voltage divider: 1K:20K)
• Static power: 200mA@5V with Betaflight, 150mA@5V with ArduPilot
• FC Firmware support: ArduPilot(ChiBiOS): MATEKH743 | BetaFlug: MATEKH743 | INAV: MATEKH743 (Will be supported soon)

Content

• H743-SLIM
• 6x silicone rings M4 on M3
• 1x JST-SH1.0_8pin cable, 5cm
• 2x JST-SH1.0_8pin connectors
• 1x JST-GH-4P to JST-GH-4P cable for CAN port, 20cm