BrainFPV Radix F4 FC with OSD

BrainFPV Radix F4 FC with OSD

Product description

BrainFPV Radix F4 FC with OSD

The BrainFPV F4 Flight Controller with OSD from Radix works with the currently fastest STM32 F4 processor with 180 MHz. This enables an incredibly good flight performance with the Racecopter. Even for long range pilots the Flight Controller pays off, because BrainFPV has the integrated barometer on board. The Flight Controller not only offers the possibility to connect to the controller via plugs, but also the option to establish a connection via individual solder contacts on the bottom side. Another advantage is the connection of the FPV camera to make settings directly on the field with the copter. Another cool feature is the possibility to display your own logo in OSD mode with a single click. Due to the compact and clear design of the BrainFPV Radix F4 FC with OSD the assembly is very easy and possible construction errors are reduced for a perfect result of the flight controller for the drone. Numerous extras, such as the integrated graphic barometer, 3D-OSD support or a superimposed horizon increase the fun factor!

Technical specifications

• Processor: STM32F446RET6, Coretx-M4, 32 Bit, 180 MHz, 128 KB RAM, 512 KB Flash
• IMU: Bosch Sensortec BMI160 with 3.2 kHz works with SPI
• Barometer: Bosch Sensortec BMP280 works with SPI
• OSD: PAL / NTSC, automatic detection, adjustable b/w layers at full resolution (full Betaflight OSD support with additional graphical features; support for side-by-side 3D when used with a 3D FPV camera)
• Memory: MicroSD slot for the drone's protocol
• Motor outputs: up to 6 outputs are supported with DSHOT (150/300/600/1200) and OneShot
• Receiver: PPM, S.Bus (including inverter), DSM, HoTT, SRXL, CSRF, FPort ready
• Telemetry support: FrSKY smart port, FrSKY sensor hub, HoTT telemetry, SRXL, CSRF, FPort-enabled;eIntegrated inverter for FrSKY telemetry
• Serial Ports: 4 full serial ports (UARTs). UART3 and UART6 have inverters for S.Bus and SmartPort telemetry. Inverters are automatically enabled and disabled for maximum flexibility.
• RGB LEDs: LED output
• Camera control: output for accessing the camera's OSD (On Screen Display)
• IR Emitter: Output for infrared based timing systems via protocols like I- Lap, Trackmate (requires external IR LED and drivers)
• Buzzer port: 5V output for buzzer with a strength of 100 mA maximum
• Analog inputs: Volt sensor up to 35 V, current and RSSI inputs (max. 3.3 V)
• Power: 4.5 V to 5.5 V, 120 m
• Dimensions: 37 mm x 37 mm, 30.5 mm hole spacing
• Weight: 6 g

Scope of delivery

• 1 x Radix F4 Flight Controller
• 4 x soft mount rubbers
• 1 x connection cable (direct connection to the Hobbywing 4in1 ESC)