Holybro PM02 V3 12S Power Module for Pixhawk Analog

Holybro PM02 V3 12S Power Module for Pixhawk Analog

Product description

A flight controller without a clean power supply is like a brain on bad coffee—technically functional, but eventually strange things will happen. That’s exactly why the Holybro PM02 V3 Power Module is an essential component of modern Pixhawk and ArduPilot setups.

This compact power module reliably supplies your flight controller with stabilized 5.2V at up to 3A while simultaneously measuring your system’s voltage and current consumption with precision. The data is transmitted analogically to the flight controller—ideal for telemetry, battery monitoring, and safe flight planning.

The PM02 V3 supports 2S to 12S LiPo batteries, making it suitable for both compact drones and high-performance long-range or heavy-lift platforms. With a current measurement capacity of up to 120A, there’s plenty of headroom even for powerful setups.

Particularly convenient: Holybro ships the module with pre-soldered XT60 connectors, 12 AWG cables, and a 220uF capacitor. This saves time during setup and reduces potential sources of error. Heat shrink tubing provides additional protection for the electronics—a small detail that shows this product is built on genuine FPV and autopilot experience.

The analog signal transmission makes the module perfect for classic Pixhawk systems. However, it’s important to note that newer controllers like the Pixhawk 5X or 6X require a digital power module. Technology is sometimes like evolution—compatible until it suddenly invents new connectors.

In short: The Holybro PM02 V3 delivers stable power, precise readings, and a reliable power supply for professional flight controller setups.

Technical Specifications

General

• Model: Holybro PM02 V3
• Type: Analog power module for Pixhawk

Input & Output

• Input Voltage: 2S – 12S LiPo
• Output Voltage: DC 5.2V
• Maximum Output Current: 3A

Current Measurement

• PCB continuous current: 60A
• PCB peak current: 100A (<60 seconds)
• Maximum current measurement: 120A

Sensor values

• Voltage divider: 18.182
• Amperes per volt: 36.364

Connections

• XT60 connector (pre-soldered)
• JST-GH 6-pin
• Molex 6-pin

Electronics & Protection

• Integrated 220uF 63V capacitor
• Heat-shrink tubing protection for the circuit board
• Analog voltage and current output

Cable

• 12 AWG power cable
• Cable length: 15 cm

Dimensions & Weight

• Weight: 20 g

Compatibility

Compatible with:

• Pixhawk Standard
• Pixhawk 4
• Pixhawk 2.4.6
• ArduPilot systems
• PX4 systems

Not compatible with:

• Pixhawk 5X
• Pixhawk 6X (these require digital PM modules such as the PM02D)